Společnost
Innovations
Service
Produkty
Obrázek může zobrazovat podobný produkt.
Part No.: 37537 000D
QUADRON 185Power
pojistková odpínací lišta 250 A
velikost 2, 1-pólové odpínání
V-clamp 50-300 mm²
terminal body alu, pressure piece brass
pro přípojnici 30, 40, 60, 80, 100, 120 x 10
System
185Power
Advantages of the product
Cover can be locked when closed.
| Produktová skupina | 12 |
| Podskupina | 64 |
| velikost balení | 36 |
| EAN | 4021267375355 |
| ECLASS 14.0 | 27142108 |
| ETIM 5.0 | EC001046 |
| ETIM 8.0 | EC001046 |
| ETIM 10.0 | EC001046 |
Standardy
IEC 60947-1:2020
IEC 60947-3:2020 AC ratings only
typové číslo: QU185-2
| pro velikost pojistek: | NH 2 |
| pojistková vložka podle na standardu: | IEC / HD 60269-2 |
| povolené rozptylování energie pojistkové vložky: | 34 W |
| requirements for contact parts: |
Fuse links with silver-plated contact pieces recommended. For fuse links with nickel-plated contact pieces, a reduction factor of 0.8 is to be observed. |
| Detaily IEC | |
| Standardy | |
|
IEC 60947-1:2020 IEC 60947-3:2020 AC ratings only |
| Elektrické údaje IEC | |
| Jmenovitý proud (IEC): | 250 A |
| jmenovité napětí (IEC) AC: | 400 V |
| accuracy class (current): | 0.5 |
| jmenovité izolační napětí Ui AC: | 1000 V |
| jmenovité přepětí Uimp : | 8 kV |
| Utilisation category AC (IEC 60947-3) : | AC-22B (400 V / 250 A) |
| 120 kA / 400 V (250 A) | |
| schváleno s pojistkovými vložkami dané třídy: | gG |
power dissipation of the article:
The power dissipation at a typical load of 80 % results to 38,4 W.
(The power dissipation at full load would be 60,0 W.)
| Supplementary data IEC | |
|
The following values have been verified with tests under certain conditions. Please ask Wöhner for this conditions before designing your panel. |
| further utilisation category DC (IEC 60947-3): | DC-20B max. voltage between the fuses: 1000V visible information required: Do not switch under load. |
| A fuse-combination unit acc. to IEC 60947-3 can only be operated at a higher voltage than its rated voltage, if it is used as a fuse-disconnector without breaking capacity, up to its max. rated insulation voltage and labelled as such. |
| min. permitted operation temperature | -40°C |
| max. permitted operation temperature | 55°C |
| min. permitted temperature for transport and storage | -40°C |
| Besondere Betriebsbedingungen gemäß IEC / EN 61439-1 können zu Fehlauslösungen von Meldeschaltern oder Sicherungsüberwachungen führen. Die vorliegenden Betriebsbedingungen sind dementsprechend bei der Auswertung der Meldesignale zu berücksichtigen. | |
| Degree of protection IP20 at front, degree of protection near terminal depends on installation |
| Mechanické údaje | |
| Š x V x H: | 100 x 844 x 190 |
| hmotnost: | 543,0 kg/100 |
| póly: | 3-pólový |
| pro přípojnici: | 30, 40, 60, 80, 100, 120 x 10 |
| čelní stupeň ochrany: | IP20 |
| degree of protection when open: | IP10 |
| Terminal points | |
| v-clamp | |
| min. cross-section: | 50 mm² |
| max. cross-section: | 300 mm² |
| re: | 70 - 150 mm² |
| rm: | 50 - 120 mm² |
| se: | 70 - 300 mm² |
| sm: | 70 - 240 mm² |
|
Suitable for aluminium conductors. the temperature of aluminium conductors must not exceed 80°C (see operating instructions) pre-treatment of aluminium conductors: see general technical information (under Downloads) |
|
| Vlastnosti materiálu | |
| halogen-free: | Yes |
| Suitable for aluminium conductors. the temperature of aluminium conductors must not exceed 80°C (see operating instructions) pre-treatment of aluminium conductors: see general technical information (under Downloads) |
|
| A fuse-combination unit acc. to IEC 60947-3 can only be operated at a higher voltage than its rated voltage, if it is used as a fuse-disconnector without breaking capacity, up to its max. rated insulation voltage and labelled as such. | |
|
The terminal compartment cover 33733 is always needed for the connection at top and when using cable lugs. |
|
| povolené rozptylování energie pojistkové vložky: | 34 W |
| requirements for contact parts: |
Fuse links with silver-plated contact pieces recommended. For fuse links with nickel-plated contact pieces, a reduction factor of 0.8 is to be observed. |
Find your contact
to the contact site
Wöhner GmbH & Co. KG
Elektrotechnische Systeme
Mönchrödener Str. 10
96472 Rödental
Order hotline (Germany)
+49 9563 751 161
order@woehner.de
Technical hotline (Germany)
+49 9563 751 260
support@woehner.com
Stát
