NH fuse-base 250 A, panel mounting, for PV (03288)

The picture may show a similar product.

Part No.: 03288000

QUADRON^®Panel

NH fuse-base 250 A, panel mounting, for PV

incoming connection screw M10, outgoing connection to busbar 2x 30 x 10, for integrated mounting of CTs type LEM HTA

size 1XL / 1P, with touch protection

für Montageplatte

System

Mounting plate

Advantages of the product

For one or two internal busbars 30x10mm.
Busbar fully shock protected by the contact cover.
The shock protection is split into 2.

Product group	10
Subgroup	07

pack size	3
EAN	4021267032883

catalog page

2020 : 6.11

Standards

IEC 60269-1:2006 + A1:2009 + A2:2014
IEC 60269-2:2013 + A1:2016

fuse links acc. to standard:

IEC / EN 60269-6

rated voltage (IEC) DC:

1500 V

rated surge voltage U_imp :	6 kV

The insulation performance of the article depends on the installation conditions.

short-circuit strength when protected by fuses:

50 kA

power dissipation of the article:

The power dissipation at a typical load of 80 % results to 3.5 W.

(The power dissipation at full load would be 5.5 W.)

Supplementary data IEC
The following values have been verified with tests under certain conditions. Please ask Wöhner for this conditions before designing your panel.

for fuse links IEC 60269-6

Terminal points
Not suitable for aluminium cables !

Connection screws for busbars: Hexagonal screw M10, length across flats 16, tightening torque 30Nm connection width 25mm fastening to mounting plate: 2x 10.5mm hole, intended for hexagonal screw M10, tightening torque 5Nm